Start With Where the Yellow Is
Look at which leaves turned first. Nutrients such as nitrogen and magnesium move inside the plant, so when the solution runs short the vine pulls them out of its oldest, lowest leaves to feed new growth. Yellowing that starts at the bottom and works up points to the solution. Yellowing on the newest leaves at the tips points to something that stops the plant taking nutrients up at all: cold, damaged roots, or a solution far off balance.
The Common Causes in a Kratky Container
The solution is running out
In a Kratky setup the plant drinks one fill of solution for the whole crop. Bernard Kratky ended his cucumber trials when less than 10 percent of the original solution was left. Lower leaves yellowing near the end of the season, with the solution almost gone, is the crop finishing, not a problem to fix. Pick what's left and plan the next container larger if it ran out early (see Kratky container size for cucumbers).
The solution was mixed too weak
If lower leaves yellow early, while the container is still well filled, the mix may have been too dilute. Kratky filled his cucumber containers to an electrical conductivity (EC) of 2.0 to 2.5 mS/cm. An EC meter tells you what you actually mixed, which is more reliable than counting scoops. The Kratky nutrients for cucumbers page covers mixing.
Too little light
A cucumber shaded by its own canopy, or grown indoors under a weak light, drops its lower leaves first. Pale, stretched growth with long gaps between leaves is the giveaway. See Kratky cucumbers indoors for light.
Damaged roots
Brown, slimy roots can't take up nutrients, so the whole plant yellows and wilts even with plenty of solution. That is usually Kratky cucumber root rot, often after the container was refilled too high.
What Not to Do
Don't respond to yellow leaves by filling the container back up. Raising the solution level after roots have grown into the air gap can injure the plant, which is the opposite of what a yellowing vine needs. If the solution is genuinely too weak and the level is still high, a meter reading first, then a small, measured correction, is safer than adding more water.
